Disco 2 Is this an not fail? Photo inside.
- Thread starter ldrego
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Dan_Trials
Well-Known Member
- Posts
- 2,546
Think the picture will be along shortly...
Marmaduke
Well-Known Member
- Posts
- 9,773
- Location
- Near the land of 'Me Duck'
I'd be attacking it with a wire brush to see exactly what you're looking at, personally cutting the rot out is better than plating over the top of it
Marmaduke
Well-Known Member
- Posts
- 9,773
- Location
- Near the land of 'Me Duck'
You should be fine then. You'll laugh when you see the size of the hammer the mot tester uses, it wouldn't break a lump of toffee 
This would take a good thrashing like to make a hole in that. I do need to investigate it further but not this week if you understand. My chassis protection stuff is just not working. I must have put so much man hours into it but just not getting there whatsoever. I will post up my box section repairs shortly and hopefully you can give me a little advise on whether they should pass. I was told at the previous mot place that these sections under the door sills were not structural hence gave them a shot with my welder.
stannswhite
Well-Known Member
- Posts
- 622
- Location
- leeds
i suppose it depends on the m.o.t tester,if
it passes i think it will be down as an advisory.
i hope it passes for you mate.
it passes i think it will be down as an advisory.
i hope it passes for you mate.
Similar threads
Disco 4 (LR4)
Discovery 4 issues
