Hi.
Please bear with me on this, I have done a fair bit of searching on here and other forums, but im finding myself getting confused after reasonable diagnostics (at my level)
Imported Jap 300tdi with blanked off EGR.
Starts fine all year, as soon as it gets to zero, its a pain in the arse.
It will crank over, but wont fire, then the cranking kills the battery so I swap it with a charged one and it fires up etc etc ad invinitum
Relay clicks ok, Fuses fine, Battery starts off at around 15.4v and is 1000CCA
I put a multimeter on the glow plug tip and the neg on the engine case and it reads 0, put neg on battery and its 0.1v (Would Amps be more use ?)
And then yesterday I noticed it started fine after a previously unseen coil light appeared, and it started in a kind of cold I wouldnt normally expect it to start in. Not seen that light again (hence me looking up relay probs and checking for clicks and fuses etc)
I ordered new plugs earlier this week, will that fix it? there appears to be a bigger issue with power reaching the plugs (unless im being a div which is more than likley)
Any ideas on what I need to check next ?
Please bear with me on this, I have done a fair bit of searching on here and other forums, but im finding myself getting confused after reasonable diagnostics (at my level)
Imported Jap 300tdi with blanked off EGR.
Starts fine all year, as soon as it gets to zero, its a pain in the arse.
It will crank over, but wont fire, then the cranking kills the battery so I swap it with a charged one and it fires up etc etc ad invinitum
Relay clicks ok, Fuses fine, Battery starts off at around 15.4v and is 1000CCA
I put a multimeter on the glow plug tip and the neg on the engine case and it reads 0, put neg on battery and its 0.1v (Would Amps be more use ?)
And then yesterday I noticed it started fine after a previously unseen coil light appeared, and it started in a kind of cold I wouldnt normally expect it to start in. Not seen that light again (hence me looking up relay probs and checking for clicks and fuses etc)
I ordered new plugs earlier this week, will that fix it? there appears to be a bigger issue with power reaching the plugs (unless im being a div which is more than likley)
Any ideas on what I need to check next ?