Thank you for all the help. I’m gonna take the play completely out of the shaft to see if that fixes it. Thanks again.
Intermediate gear on lt230
- Thread starter Dutchy7
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Thank you for all the help. I’m gonna take the play completely out of the shaft to see if that fixes it. Thanks again.
tottot
Well-Known Member
- Posts
- 8,031
- Location
- west wales coast
Seams to me that the shaft had been loose for some time before you spotted it and has worn the holes in the casing. As James says do not over tighten as this will soon destroy bearings. If you can eliminate as much movement as possible without binding up the gear bearings and keep the oil topped up it may well get you home. Good luck.
So then I’m looking at an overhaul of the transfer case all together? Buying a new box like James said?
tottot
Well-Known Member
- Posts
- 8,031
- Location
- west wales coast
Looks like it may be going that way [repairing your case may or may not be an option ] but plenty about in the UK and you may want to have a disco one with higher gearing.
Got the feeling you were trying to keep going untill you got it home.
Got the feeling you were trying to keep going untill you got it home.
I have actually been driving on it for some time. So I think it might be time to get a re furnished one. Thank you for the help.
Anywhere you would suggest getting one from?
tottot
Well-Known Member
- Posts
- 8,031
- Location
- west wales coast
Ashcroft.
Real quick update. Finally got the nut off of the shaft. What happen was that when I thought I was tightening it I wasn’t. The shaft was twisting with the nut. I had to hammer and chisel it off to turn it without turning the shaft. Any advice on how to put the next one on without the shaft turning with the nut? I ordered a new nut. A picture is available of the thread point and nut.
Attachments
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
shaft has a flat and so doe the plate secured by the 8mm bolt but 10mm socket size in your pic, if it rotates plate must be damaged frc7452
Thanks James. Makes sense. I’ll keep you guys posted once both are put back on. Keeping my fingers crossed it does the job. Thanks to you both for your patience.
