robbie the greatl
Active Member
- Posts
- 176
- Location
- uk,
my injectors came loose so i tightened down the 8 mm bolt it cured it but still a little chuff under load so i tightened more while hot now ok is this ok or do i need to replace seals
injector chuffing
- Thread starter robbie the greatl
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
tottot
Well-Known Member
- Posts
- 8,028
- Location
- west wales coast
Keep an eye on it. You do not say which engine.
- Posts
- 4,549
robbie the greatl
Active Member
- Posts
- 176
- Location
- uk,
thank you for your replys and advice the top round injectors is clean and i put soapy water round them before second tightening and no bubbles or pressure showing so i nipped them down a bit if it starts again i will do the necessary new seals ,washers and bolts thanks again by the way its 2.4 puma
robbie the greatl
Active Member
- Posts
- 176
- Location
- uk,
2.4 puma
Rougharse Racing
Well-Known Member
- Posts
- 883
- Location
- The Grim North
As others have said, keep an eye on it, leaking injectors can let carbon build up around the injectors and jam them in. I have seen pictures of vans being lifted off the ground while trying to get stuck injectors out.
