I've got 2 1.8 hippos, 1 has an electrical fault where the rear door takes it upon itself to actuate and then when the vehicle is stopped, the car will not turn over again and all the doors start clicking and then wont lock, and it refuses to start unless the battery is disconnected then restarted.
My other Hippo has no key fob so needs the EKA code to disable the immoilizer which I have.
My thoughts are that if I change the ECU and 27VT from the 5dr with no fob, on to the one with the electrical issues, I then input the EKA code into the door lock and if the immobilzer and engine function as they should I have found the source of the issues.
Alternatively if I can connect the ECU & 27VT from the faulty hippo on to the 5dr and see if that runs right and works off the fob without issues then I can assume it's the faulty hippo's loom/ earths that's causing the faults.
Can the EKA for a vehicle be put into another vehicles lock if it uses the ECU & 27VT that the EKA is matched to?
Is there anything else that needs to be swapped over for this to work?
My other Hippo has no key fob so needs the EKA code to disable the immoilizer which I have.
My thoughts are that if I change the ECU and 27VT from the 5dr with no fob, on to the one with the electrical issues, I then input the EKA code into the door lock and if the immobilzer and engine function as they should I have found the source of the issues.
Alternatively if I can connect the ECU & 27VT from the faulty hippo on to the 5dr and see if that runs right and works off the fob without issues then I can assume it's the faulty hippo's loom/ earths that's causing the faults.
Can the EKA for a vehicle be put into another vehicles lock if it uses the ECU & 27VT that the EKA is matched to?
Is there anything else that needs to be swapped over for this to work?
Last edited: