Idler Pulley Replacement

dunning123 · Oct 16, 2018

I've replaced the idler pulley bearing (blue arrow) with a Timken 6303 bearing as it was beginning to make noise, has anyone replaced the bearing the pulley shown by the red arrow? Can't find anything online about that one. Gonna take it apart tomorrow for a look but though I'd chuck this up see if anyone has any knowledge on it to help me!

Cheers

tom1979 · Oct 16, 2018

Normally just replace the whole items rather than dismantling and replacing bearings.

dunning123 · Oct 16, 2018

tom1979 said:
Normally just replace the whole items rather than dismantling and replacing bearings.

Or you could save a few quid and provide a semi-habital planet for your kids kids to live on..

KISSMYAURA · Oct 16, 2018

still trying to find the gates or dayco part numbers for those two on a 15P td5

tom1979 · Oct 16, 2018

dunning123 said:
Or you could save a few quid and provide a semi-habital planet for your kids kids to live on..

With so much time on your hands I’m sure you’ll get to the bottom of it. They’re probably the same bearing

dunning123 · Oct 17, 2018

tom1979 said:
With so much time on your hands I’m sure you’ll get to the bottom of it. They’re probably the same bearing

Dunno where you get that assumption. If I had all this time wouldn't be posting on here asking for helpful advice to save me time would i.

Kev12 · Oct 22, 2018

Easiest way is to dismantle it and give it a proper measure, then put the size into one of the many bearing suppliers on the web

Idler Pulley Replacement

dunning123

Member

Attachments

tom1979

Well-Known Member

dunning123

Member

KISSMYAURA

Well-Known Member

tom1979

Well-Known Member

dunning123

Member

Kev12

Well-Known Member

Similar threads