How do i get around this little problem..

abcdedd · Nov 16, 2012

SO guys,

My wheel baring collapsed.. and my my it has made a mess, completely ****ed my half shaft.. BUt how do you guys suggest i get around this problem? the shaft is completely been made oval rather thatn round, which means obviously im goign to struggle to get it all apart... Ideas welcomed..

Pictures:

Thor1950 · Nov 16, 2012

new bearing and half shaft will fix it

jamesmartin · Nov 16, 2012

cut the stub axle end off nuts will spit easily with a decent chisel

abcdedd · Nov 16, 2012

Right o- needto get my hands on a grider. One of those things that ive always needed but never bought... Cut stub axle back chisel nuts off and then remove assembly...

Okanooba · Nov 16, 2012

Just rebuilding my front axle not a bad job but just getting all the gaskets and bits was a pain !

Good luck

Soloby Rob · Nov 16, 2012

abcdedd said:
SO guys,

My wheel baring collapsed.. and my my it has made a mess, completely ****ed my half shaft.. BUt how do you guys suggest i get around this problem? the shaft is completely been made oval rather thatn round, which means obviously im goign to struggle to get it all apart... Ideas welcomed..

Pictures:

I would just like to know, how the hell did you manage to let it get that bad

warrior · Nov 16, 2012

I've just done my front off side half shaft and cv and rear bearings, simple answer is scrapers,

abcdedd · Nov 16, 2012

Soloby Rob said:
I would just like to know, how the hell did you manage to let it get that bad

Its weird, i only checked all the wheels a couple of weeks ago, then on the m25 the other day, veered to the right and lost power, this happened.. pretty confused really!

Worrying...

top-cat · Nov 16, 2012

abcdedd said:
Its weird, i only checked all the wheels a couple of weeks ago, then on the m25 the other day, veered to the right and lost power, this happened.. pretty confused really!

Worrying...

thats not had grease in it for a long while

abcdedd · Nov 16, 2012

Yeh i figured haha, will be properly greased up by the time im done with it :smokin:

abcdedd · Nov 19, 2012

Let the cutting commence!

How do i get around this little problem..

abcdedd

New Member

Thor1950

Well-Known Member

jamesmartin

Well-Known Member

abcdedd

New Member

Okanooba

New Member

Soloby Rob

Banned

warrior

Well-Known Member

abcdedd

New Member

top-cat

Well-Known Member

abcdedd

New Member

abcdedd

New Member

Similar threads