mik100
Member
- Posts
- 57
- Location
- Carcassonne France
Hello
I have a problem with my HEVAC. The test book symbol came on and so I hooked it up to my RCL and got the fault "(4) THE RIGHT HAND BLEND MOTOR SHORT CIRCUIT TO POSITIVE" I cleared the fault and tried to force the motor to both extremes and then recalibrated them. It was ok for about 12km and then the book came on again. I looked at it again and tried to recalibrate the motors and got a reading of 0 for the l/h one and 254 !!!for the r/h one. The right hand one would not shift. This morning, the book did not appear it was a bit cold so both blew slightly warm I looked at it when I got to work and it had the old fault logged but no new ones. I went out again and it worked fine until lunch time when the book came back. I reclibrated the motors again and got the same readings as before. drove it a bit with the comp hooked up and moving the temp from min to max. It then started working again. So my question is do you think the flap is sticking and if so how is it fixed?
Thanks in anticipation.
Regards
Mik
I have a problem with my HEVAC. The test book symbol came on and so I hooked it up to my RCL and got the fault "(4) THE RIGHT HAND BLEND MOTOR SHORT CIRCUIT TO POSITIVE" I cleared the fault and tried to force the motor to both extremes and then recalibrated them. It was ok for about 12km and then the book came on again. I looked at it again and tried to recalibrate the motors and got a reading of 0 for the l/h one and 254 !!!for the r/h one. The right hand one would not shift. This morning, the book did not appear it was a bit cold so both blew slightly warm I looked at it when I got to work and it had the old fault logged but no new ones. I went out again and it worked fine until lunch time when the book came back. I reclibrated the motors again and got the same readings as before. drove it a bit with the comp hooked up and moving the temp from min to max. It then started working again. So my question is do you think the flap is sticking and if so how is it fixed?
Thanks in anticipation.
Regards
Mik
