Datatek
Well-Known Member
- Posts
- 44,899
- Location
- Near Poitiers SW France
Getting info is a bit like pulling teeth without an anaesthetic
Help pleaseeeeee
- Thread starter adamnbecky2010
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
adamnbecky2010
New Member
- Posts
- 90
- Location
- boston/lincolnshire
No engine doesn't spin as you turn the key it just beeps and says engine immobilised press remote .transfer nuetral gone now as I've put on new battery
Datatek
Well-Known Member
- Posts
- 44,899
- Location
- Near Poitiers SW France
Really needs diagnostics IMO to see if the BECM is getting a valid FOB code amoungst other things..
adamnbecky2010
New Member
- Posts
- 90
- Location
- boston/lincolnshire
Don't know if this helps but central locking isn't working only drivers door
Datatek
Well-Known Member
- Posts
- 44,899
- Location
- Near Poitiers SW France
Does the drivers door locking work from the FOB?
adamnbecky2010
New Member
- Posts
- 90
- Location
- boston/lincolnshire
Not by the button only by turning the key anticlockwise
Datatek
Well-Known Member
- Posts
- 44,899
- Location
- Near Poitiers SW France
So the FOB is not working or the RF receiver is faulty or disconnected or there is a BECM fault by the sound of it. Still needs P38 specific diagnostics.
If the FOB/RFreceiver etc was working, pressing the button would sort the problem. Have you checked to see if the RF receiver is connected?
adamnbecky2010
New Member
- Posts
- 90
- Location
- boston/lincolnshire
Rf receiver is connected and it's the green spot updated version
adamnbecky2010
New Member
- Posts
- 90
- Location
- boston/lincolnshire
It was an autel Maxisys that diagnosed my car and the error was anti theft alarm serial link fault error code 94
- Posts
- 16,479
....and the syncmate you have tried is for the THOR engine?
If it is and you still get no comms....the BeCM could be in an alarmed state....you'll need some decent P38 Diags to sort that
If it is and you still get no comms....the BeCM could be in an alarmed state....you'll need some decent P38 Diags to sort that
You need a proper diagnostic reader, not just obd2
giving this a break now, to painful :multiply:
adamnbecky2010
New Member
- Posts
- 90
- Location
- boston/lincolnshire
Is there any one on here that will come and do a diagnostic I'm willing tompay the going rate please
Look on rescue map for red circles with spark, click and it will tell you what kit they have
adamnbecky2010
New Member
- Posts
- 90
- Location
- boston/lincolnshire
So just looked and nobody anywhere near me with nanocom for my rangie fanbloodytastic
Key code lockout means you have lost sync. First, replace the batteries in your key fob, second, find the manual and read very thoroughly through the instructions for entering the EKA-code. Follow the procedure to the letter and on the final turn of the key your doors should all unlock and indicators flash. If you do this right and there's nothing else wrong with your car, it should fire right up. You can search the forum as well for tips on EKA code entering.
Good luck
