doublemint
New Member
- Posts
- 8
- Location
- London
Does anyone near west London have a Syncemate? My '97 4.6 won't start. It cranks but doesn't fire up. No engine check light.
HELP!! P38 - Sync Mate in London
- Thread starter doublemint
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 33,436
- Location
- North Shropshire
Have you done the basic checks? Battery, fuel, spark? Any message on the dash?
doublemint
New Member
- Posts
- 8
- Location
- London
Yes. all seems fine. only message on dash is my LH rear window is not set but that was a known issue before.
- Posts
- 33,436
- Location
- North Shropshire
Does it unlock with the fob or do you use the key?
By 'all seems fine' do you mean you're getting a spark and the plugs are wet?
By 'all seems fine' do you mean you're getting a spark and the plugs are wet?
doublemint
New Member
- Posts
- 8
- Location
- London
Yes the doors unlock and lock with he fob.
Yes I am getting a spark
Yes I am getting a spark
- Posts
- 33,436
- Location
- North Shropshire
Is the red LED in the middle of the front window flashing? Sounds like a sync issue if it's not getting fuel.
Have you checked the fuses and relays? No harm in swapping the engine relays in case one is sticking
If you're getting a spark then other things like the CPS are ok
Not sure what else to suggest
Have you checked the fuses and relays? No harm in swapping the engine relays in case one is sticking
If you're getting a spark then other things like the CPS are ok
Not sure what else to suggest
doublemint
New Member
- Posts
- 8
- Location
- London
The LED doesnt flash after i press the unlock on the fob.
Yeah fuses looks good.
I should also mention, the car would crank but not fire. I got the battery tested and it was nearly dead, I believe due to the RF receiver issue(I still have the blue dot). I took the battery out and got it charged. It still doesnt want to fire u.
Yeah fuses looks good.
I should also mention, the car would crank but not fire. I got the battery tested and it was nearly dead, I believe due to the RF receiver issue(I still have the blue dot). I took the battery out and got it charged. It still doesnt want to fire u.
- Posts
- 33,436
- Location
- North Shropshire
You need to check the voltage while the engine is cranking, it could be dropping too low
doublemint
New Member
- Posts
- 8
- Location
- London
Ok, if it does drop too low, how can I resolve it?
- Posts
- 33,436
- Location
- North Shropshire
Charge the battery again, if it's not holding a good charge them you'll need a new one. You shouldn't see much less than 11v during cranking with a decent battery. Maybe 10.8v as a real minimum
doublemint
New Member
- Posts
- 8
- Location
- London
Apologies maybe my explanation wasn't clear, I did charge it too 100% then connected it to the car(almost immediately) then attempted to start it. Same issue.
- Posts
- 33,436
- Location
- North Shropshire
You still need to check the cranking voltage 
if it's too low it can crack but not start.
A battery can die internally so the surface voltage looks good but as soon as you apply a load it wets itself.
Not saying it's the issue but needs to be checked
if it's too low it can crack but not start.A battery can die internally so the surface voltage looks good but as soon as you apply a load it wets itself.
Not saying it's the issue but needs to be checked
doublemint
New Member
- Posts
- 8
- Location
- London
Understood. Thanks again.
- Posts
- 3,862
- Location
- Near Heathrow.
Are the sparks on all eight good & strong ? Is there fuel pressure in the injector rail ? (check by depressing the schrader valve briefly)
Also "West London" is a bit vague & quite a large area. Where ? Might be one of us near with Nanocom
Also "West London" is a bit vague & quite a large area. Where ? Might be one of us near with Nanocom
doublemint
New Member
- Posts
- 8
- Location
- London
Here's an update:
The issue was was resolved by using Sync Mate. I ended up buying one from Andy of p38spares . com. Thank you everyone for walking me thru and narrowing down the issue. You guys rock!!
The issue was was resolved by using Sync Mate. I ended up buying one from Andy of p38spares . com. Thank you everyone for walking me thru and narrowing down the issue. You guys rock!!
