Help needed

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
I bought this animal for the job off ebay. 10 tonne press.
 

Attachments

  • Randoms 291.jpg
    Randoms 291.jpg
    319 KB · Views: 159
What about getting my nearest tyre barrage to use their impact guns to loosen them. Would that work?

It's a landy - anything's worth a try. Personally I'm a firm believer in a breaker bar and four foot of scaffold pole. Something has to give......

The last time I did springs I had to do it the hard way - hacksaw through the bolts and bushes.
 
It's a landy - anything's worth a try. Personally I'm a firm believer in a breaker bar and four foot of scaffold pole. Something has to give......

The last time I did springs I had to do it the hard way - hacksaw through the bolts and bushes.

keep applying penetrating fluid and try again next weekend or use a 1 mm cutting disc in a 4 and a half inch grinder, my favourite tool :)

please feel free to edit :)
 
I ended out cutting off threaded bit sticking out then grinding it whole lot back untill there was nothing left.

Took about 20 mins - no pretty - but effective.

Have you sorted it yet? PM if you need help..... I an in North hants alot.
 
Oh worth doing 2" shacs makes a big difference - drives much better - be careful - hope your drive shafts are in good shape - I found vibration can be exagerated!!!! Then again my original ones where properly ****ed...
 
Still not ha another crack at the yet as been working. I've given them a good dousing of WD40 and will keep spraying it on and plan to have another go after boxing day.
I might very well take you up on the offer.
Many thanks.
 
Back
Top