P38A Heater Flap Alignment Pictures ??

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
pwood999

pwood999

Well-Known Member
Full Member
Posts
3,878
Location
Near Heathrow.
While my heater box is out of the car, I've been sorting to stiff distribution flaps. Forgot to take a photo of the original positions. The front flap that does the footwell vents can only go one way, but the face & screen flaps can easily be 90 or 180 degrees out, because the square bar fits in multiple positions.

Does anyone have either a picture of where they should be, or an airflow diagram for the P38 ? Cannot find anything in RAVE.

Pete
 
This is where mine was before I touched it...


IMG_3721.jpg


If you rotate the distribution cog all the way clockwise, that's full screen, so you could just line it up like that I think?

IMG_3719.jpg
 
Last edited:
Yes I can get the gears correctly aligned, but the top right one in your picture can fit onto the square shaft in different positions. This means the screen flaps can be 90deg wrong !!

Found this picture online & added my annotations. It's unclear if those positions are with the gears removed or not.
I do have another heater box ordered, so hopefully it's un-tampered with.

1706018737865.png
 
In that position (on my picture) the flaps would be least hinderence to air flow, at the other end of the travel they'd be closed. Can you not put the sides back on you box and see where the flap are and adjust them accordingly?

In your picture above, the screen flaps look in the closed position, so that would be distribution cog fully counter clockwise, and then push the screen cog on.
 
MrGorsky said:
In that position (on my picture) the flaps would be least hinderence to air flow, at the other end of the travel they'd be closed. Can you not put the sides back on you box and see where the flap are and adjust them accordingly?

In your picture above, the screen flaps look in the closed position, so that would be distribution cog fully counter clockwise, and then push the screen cog on.
Click to expand...

Counter-clockwise? You can tell you spent time in the States. Anticlockwise in the UK.
 
You must log in or register to reply here.

Similar threads

pwood999
P38A Sticky Flaps
Replies
7
Views
383
Grrrrrr
Grrrrrr
M
P38A Heater box binding the flaps with pictures
Replies
11
Views
1K
Mukiwa
M
Nodge68
Freelander 2 (LR2) LR trouble codes.
Replies
6
Views
33K
Keith Kernow Kernewick
Keith Kernow Kernewick
Saint.V8
L322 2002-2005 Heater Matrix Replacement
Replies
14
Views
14K
yfo866
yfo866
rasheed
distribution and blend flap positioning
Replies
5
Views
2K
rasheed
rasheed
Back
Top