Headlining

Hicap phill said:

Is it for your interior light?

Click to expand...

Yes, but it holds the Liner off a few inches in the middle, think if it was cut or even moulded more in to it , it would sit right up on the roof, with no sagging.

Got the rear section up, fits Good, no Sag with the clip right in the middle, ran the wire for light through to dash for later , just waiting to try some Velcro before I place the centre piece up.

border said:

Did the middle go up OK or did it still sag ?

Got it given off a bloke last week, he does repairs in post offices and it was on the floor in the door way of one, very hard wearing stuff, should last a good while.

Click to expand...

Any chance you could pm me a few pics please? I had a bit of welding/leak on mine and I ripped the foam off the vinyl - it says more now lol. I was going to velcro carpet in so I can pull it to weld etc

border said:

Yes, but it holds the Liner off a few inches in the middle, think if it was cut or even moulded more in to it , it would sit right up on the roof, with no sagging.

Click to expand...

yes but if you carfully cut around it and then fit and interior light the light unit will hold the headlining up in place as well.

Finally got it up, Velcro from Halfords seems to have worked a treat, well unless I go up in the morning and its fell off.
Got the centre section in, just needs a few bits pushing in here and there but it will do me.
Went and smashed the inner workings on my Interior light, the bit where the wire and bulb goes in , not sure if You can get them separate or not as the rest is OK, wouldn't care I had the bloody thing lighting up aswell.