- Posts
- 33,600
- Location
- North Shropshire
They seem to be 640x480, as you say better than nowt
Freelander 1 Head Gasket Leak - sorted then unsorted again
- Thread starter andyfreelandy
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
GrumpyGel
Well-Known Member
- Posts
- 26,390
- Location
- Christchurch, New Zealand
Mine turned out to be more Cefax than early webcam!
The image on that link is more photo shopped than a fashion model on the front page of Vogue.
Sorry to hear that Andy, but now at least you can fix it, and be confident to use it properly again.
Of course it's entirely possible that the HG failure, is secondary to the coolant loss, especially as No4 is furthest from the pump.
andyfreelandy
Well-Known Member
- Posts
- 5,563
- Location
- Devon
Thanks Rob, sadly not. See
https://www.landyzone.co.uk/land-rover/1-8k-head-gasket-replacement.378901/
Hopefully the new elastomer gasket will fix it.
https://www.landyzone.co.uk/land-rover/1-8k-head-gasket-replacement.378901/
Hopefully the new elastomer gasket will fix it.
Pitty!
Head gasket replacement is not too difficult. Just take it slow and be methodical
andyfreelandy
Well-Known Member
- Posts
- 5,563
- Location
- Devon
All going OK so far.
Hope the elastomer will manage with the 0.5 thou high liner in cyl 4.
Hope the elastomer will manage with the 0.5 thou high liner in cyl 4.
It'll be fine, as the elastomer gasket has thicker fire rings, which allow for I higher clamping force to be applied.All going OK so far.
Hope the elastomer will manage with the 0.5 thou high liner in cyl 4.
Make sure you use an accurate torque wrench. I'm waiting for my FL2 HG to give issues, as after doing the engine, I discovered completely by chance that my torque wrench would "break" about 20% less than the markings would suggest.
andyfreelandy
Well-Known Member
- Posts
- 5,563
- Location
- Devon
It is a new 3/8 torque wrench, doesn't mean it is spot on but hoping so.
How to easily check??
Spring balance and maths?
How to easily check??
Spring balance and maths?
Jayridium
Well-Known Member
- Posts
- 1,416
- Location
- Pedronapper (Peterhead)
Three ways of checking, one is as you say a spring balance and maths, but that leaves you at the mercy of the spring balance, so probably best to go for a known weight + radius like a One Wheel Up Test. Another is to get it calibrated by a third party. Third one is to blag a shot of a bench mounted torque tester You won't want to be buying one of those as they are around a grand. But, they give you dead on (+/- 1%) torque readings, they are widely used in marine and aviation settings. One company I used to work for wouldn't let you do anything with a torque wrench's own settings, it had to be set on a tester, and the tester itself was frequently calibrated.
That being said, I took my three torque wrenches into get a sneaky off the books calibration check (no new cert was issued) and the two new teng and the one old snapon were within one or two percent accurate across the board, so if your torque wrench is of any decent quality, ie it isn't from poundland, you should be close enough
