Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
Guess my job over Christmas
- Thread starter Karlos the jackal
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 16,357
- Location
- Benfleet, Essex
Finding the 3 missing injectors for your V8? 
mikieman
Well-Known Member
- Posts
- 332
- Location
- United States
Being sandy claws??
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
No they glow plus for 2.5tdFinding the 3 missing injectors for your V8?
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
New plugs and re wire lolBeing sandy claws??
- Posts
- 16,357
- Location
- Benfleet, Essex
Ahhhhh... sorry.
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
Your ok no need to be sorry
Just hope the old ones come out bit easy
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
I have got to do the glow plugs on one of my P38's.
Warm the engine up before trying to remove them and some Plusgas.
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
Was going to use wd40 after warmed engine up a bit
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
WD40 is a water dispersant not a release agent.
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
Didn't know if it would help with the rust around them
- Posts
- 68,232
- Location
- The Wooly Witch
Many use a slide hammer, but I'll expect a more knowledgeable dude will say otherwise ....
- Posts
- 22,904
- Location
- In the next Glen
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
Many use a slide hammer, but I'll expect a more knowledgeable dude will say otherwise
Got deep socket to undo themSlide hammer for heater plugs
- Posts
- 22,904
- Location
- In the next Glen
Yes I do thanks
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
Copperslip the threads on the new ones before you fit them.
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
Got all that just need to hope the others come out ok once engine is warm
tomcat59alan
Well-Known Member
- Posts
- 18,611
- Location
- wirral and triquivijate
You could always use a bit of heat on the plugs as long as you protect the wiring with a wet cloth.
Karlos the jackal
Well-Known Member
- Posts
- 465
- Location
- Norfolk
Should be ok once the engine warmed up abit
- Posts
- 12,628
- Location
- Sud ouest France !
Tighten them "ever so slightly" to Crack the crap and then remove. Plus gas, wd40 or any lube fine enough to run into the threads. You can spray the lube on a couple of days earlier and while using the car it'll slowly start to help.
Similar threads
Freelander 2 (LR2)
Bit of fun. Guess the job....
