Disco 1 Gear Box oil change now noisy

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
parchwba

parchwba

Active Member
Posts
123
Location
Shropshire
I have changed my gearbox oil on my Disco (R380 gearbox), and replaced the ATF with MTF94, as recommended by Ashcroft Transmissons.

The box now seems to be getting very winey and is getting louder every day. Gear change is still good. If I put the clutch in the noise stops. It’s hard to tell but I think it’s the same noise in all gears including neutral.

Before the oil change we never noticed any noise from the gearbox.

I have double checked the oil level which seeps out when I take off the filler plug (have I put in too much oil?).

There was about a thimble amount of swarf on the drainage plug when I emptied the oil.

What could be causing the noise and why is it getting louder?
Should I drain it and put some ATF in it instead?
 
so its a manual box - in that case ATF will surely kill it ?????

could be that the old oil was so thick and grotty that it prevented the noise ??????????
 
Have been in touch with Ashcroft Transmissions.
They're not sure why it's happened but have suggested I buy a particular brand of ATF oil.
Will buy and replace. see what happens.
 
parchwba said:
Have been in touch with Ashcroft Transmissions.
They're not sure why it's happened but have suggested I buy a particular brand of ATF oil.
Will buy and replace. see what happens.
Click to expand...
if you need a particular brand then box has an issue ,bearings and gears will run on nearly any oil ,baulk rings wont though ,how much oil did you put in
 
Well, putting some "Triple QX ATF Plus" (as recommended by Ashcroft)in tonight. Sounds impressive!

However, noise isn't as bad today. Gears are all still fine. Almost tempted to keep the "Triple QX ATF Plus " until the next oil change.
 
IMO the reduced noise is cos that ATF is thicker than the MTF94, that doesnt mean that the gearbox is ok as long as it's noisy with the best oil for it... i made several tests with my well working R380 with few so called ''alternatives'' cos i couldnt find MTF94 locally and the best gear change ever was with the MTF94 so i'm convinced that it's the best oil for it(recommended by the builder as well)... i'm ordering it from UK(the genuine one) rather than put other oil in my gearbox.... it's on 170K miles and still going strong
 
sierrafery said:
IMO the reduced noise is cos that ATF is thicker than the MTF94, that doesnt mean that the gearbox is ok as long as it's noisy with the best oil for it... i made several tests with my well working R380 with few so called ''alternatives'' cos i couldnt find MTF94 locally and the best gear change ever was with the MTF94 so i'm convinced that it's the best oil for it(recommended by the builder as well)... i'm ordering it from UK(the genuine one) rather than put other oil in my gearbox.... it's on 170K miles and still going strong
Click to expand...
aft is like 10w hydraulic oil in viscosity
 
My mate races cars and we always put atf in them gearboxes and they get more abuse than offroafing and all my offroaders have had atf in with no problems we use fuchs oils on account so its free to me. Atf is fine as it is dexron 2 and mtf94 is dexron 2
 
haigy said:
My mate races cars and we always put atf in them gearboxes and they get more abuse than offroafing and all my offroaders have had atf in with no problems we use fuchs oils on account so its free to me. Atf is fine as it is dexron 2 and mtf94 is dexron 2
Click to expand...
They put the M in MTF as it confused people as to why are you putting ATF in my manual transmission. The have been using ATF since the late 70's in manual transmissions
 
sierrafery said:
IMO the reduced noise is cos that ATF is thicker than the MTF94, that doesnt mean that the gearbox is ok as long as it's noisy with the best oil for it... i made several tests with my well working R380 with few so called ''alternatives'' cos i couldnt find MTF94 locally and the best gear change ever was with the MTF94 so i'm convinced that it's the best oil for it(recommended by the builder as well)... i'm ordering it from UK(the genuine one) rather than put other oil in my gearbox.... it's on 170K miles and still going strong
Click to expand...
is mtf thinner ? i thought atf was if any difference, thickness doesnt matter ,they use thin oil to reduce drag and aid cooling, r380 has a baulk ring issue,which if anything is why they changed the oil, lt77s ran very well on atf but had a better design of baulk ring for lengthethity
 
i did serious research on this comparing multiple data sheets of ATFs and MTF94 and there are differencies, maybe for some boxes few units of difference in viscosity, density or viscosity index doesnt matter but imo for the R380 is important, i know what i have experienced with different ALMOST SIMILAR oils in my perfectly working box when i hardly selected low gears on cold start when outside was below 0*C and drained out the box 3 times a month to put MTF94 in it so nobody can convince me the opposite

btw.. i didnt know they made race cars with R380 gearbox, Jamesmartin just explained about a baulk ring issue of the R380( and if somebody knows about gearboxes he does)..... i thought that's what's here about not about other more robust gearboxes or race cars.

back to the main issue in this thread: a problemless R380 doesnt have to be noisy with MTF94 whatsoever... that's a fact
 
You must log in or register to reply here.

Similar threads

ar1g3
P38A P38 rattle at idle
2
Replies
26
Views
3K
roythebus
R
N
Discovery auto gerabox issues
Replies
19
Views
1K
marjon
marjon
N
Noise from gearbox/transfer box
Replies
14
Views
2K
NeilsWheels
N
A
D2 autobox shudder issue (maybe)
Replies
8
Views
943
Stanleysteamer
Stanleysteamer
dag019
LT77 clicking loudly in 5th gear
Replies
7
Views
893
Skolmate
Skolmate
Back
Top