Gap between gearbox and cover plate
- Thread starter Evangorp
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
What engine is that?
The cover doesnt look like a seal and there appear to be 2 bolts missing. Put those back and some of the gap will disappear on tightening.
As long as the bell housing nuts are tight there shouldn't be a issue with separation.
The cover doesnt look like a seal and there appear to be 2 bolts missing. Put those back and some of the gap will disappear on tightening.
As long as the bell housing nuts are tight there shouldn't be a issue with separation.
scrappyloz
Active Member
- Posts
- 398
- Location
- Hereford,Herefordshire
Its only a cover plate. Its there to stop gravel and stones going into the flywheel. Just put the two bolts back in.
Land Raver
Well-Known Member
- Posts
- 2,015
- Location
- In the dog house
Looks Great! Can't imagine water getting in there doing any good. Best to fit the bolts & nip up
Landy-ads
Active Member
- Posts
- 407
- Location
- Out the front, spanner in hand
Try to seal it up all the way round if you can, if you wade in deep water it will get in and could ruin your clutch and starter motor
