legionnaire
New Member
- Posts
- 6
- Location
- shrewsbury
just out of interest has anyone got their chassis galvanised themselves directly rather than buying a complete new chassis ?
galvanising your chassis
- Thread starter legionnaire
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Henry_b
Think outside, no box required.
- Posts
- 15,506
- Location
- somewhere else
No point..
Hicap phill
Well-Known Member
- Posts
- 16,242
- Location
- Wiltshire
Moons ago(30years) But now it’s easier to buy direct.
No having to ensure all is correct before they dip.
No having to ensure all is correct before they dip.
There are a few threads on here from people who have had it done to a used chassis. The most recent is @border
Bobsticle
De Villes Advocaat
- Posts
- 27,632
- Location
- Manchester
Quite a few galvanisers have stopped dipping chassis because of the problems with warping.
legionnaire
New Member
- Posts
- 6
- Location
- shrewsbury
What, with the dipping to clean them or during the galvanising process?
Bobsticle
De Villes Advocaat
- Posts
- 27,632
- Location
- Manchester
It’s the heat during dipping into molten zinc.
Even my local railing company get about ten percent of dipped fencing coming back twisted. Nothing a big hammer can’t sort with a six foot panel. More of a problem with a chassis unless like the manufacturers you send it in a large jig to minimise twist.
GKN don’t send their chassis in a jig, they don’t send them at all to be fair. Are you referring to Richards Chassis?
Cps
Active Member
- Posts
- 69
- Location
- North Yorkshire
Just getting mine ready to galve now
I get a lot of work galve in my day job (fabrication business) and you can still get them done at some plants
Wedge group company policy is not to galve second had chassis . Nothing to do with distortion .they have had issues with some geting getting them blasted which is no good as all the hollow bits are full of wax/paint so makes a lot of fumes in the zink also distroys the pre treatment picked bath
Chassis need to be piro stripped in a stripping oven gets rid of all paint and wax inside and out
Wedge are all over so you need to find out who ownes the plant you take it to although wedge at hull did a 90chassis for a friend that had been piro stripped as the thought it was a new one
Distortion is the same problem weather a new chassis or old
I get a lot of work galve in my day job (fabrication business) and you can still get them done at some plants
Wedge group company policy is not to galve second had chassis . Nothing to do with distortion .they have had issues with some geting getting them blasted which is no good as all the hollow bits are full of wax/paint so makes a lot of fumes in the zink also distroys the pre treatment picked bath
Chassis need to be piro stripped in a stripping oven gets rid of all paint and wax inside and out
Wedge are all over so you need to find out who ownes the plant you take it to although wedge at hull did a 90chassis for a friend that had been piro stripped as the thought it was a new one
Distortion is the same problem weather a new chassis or old
