FWD PG1 in place of 4WD PG1+IRD?

DastardlyDan

Active Member

Posts

287

• Feb 15, 2015

• #1

Hypothetical question:

Whilst it's obvious the physical Hippo PG1 can simply be swapped to a PG1 from say, a Rover 25/45/etc, and the gearshift support may need to be modified to suit.... what about the driveshaft lengths?


Has anyone got the lengths of the front driveshafts to hand?


Would be nice to know if a relatively simple swap, to keep an otherwise mothballed Hippo on the road, whilst the IRD is being rebuilt, is possible, or if it would require custom driveshafts

 

J

jda070504

Member

Posts

92

• Feb 16, 2015

• #2

DastardlyDan said:

Hypothetical question:

Whilst it's obvious the physical Hippo PG1 can simply be swapped to a PG1 from say, a Rover 25/45/etc, and the gearshift support may need to be modified to suit.... what about the driveshaft lengths?
Has anyone got the lengths of the front driveshafts to hand?
Would be nice to know if a relatively simple swap, to keep an otherwise mothballed Hippo on the road, whilst the IRD is being rebuilt, is possible, or if it would require custom driveshafts

Click to expand...

I asked this question and due to the IRD only 1 drive shaft will fit. It was suggested that there's a possibility of a ZS shaft fitting but never got any sizes to be able to measure up.

It's not exactly helpful :lol: but it's a start at least

 

DastardlyDan

Active Member

Posts

287

• Feb 16, 2015

• #3

I've got both the short and long driveshaft from my old 220SD sat in the garage

And for some bizarre reason, the thought of simply reusing the passenger side driveshaft didn't occur to me.. I guess 3 hours of broken sleep a night will do that to you eh? :lol:

anyone fancy shuffling under their hippo, and measuring from the edge of the inner cv, to the edge of the outer cv, on the driver side?



Pleeeeease?

 

freelance

Well-Known Member

Posts

8,685

Location

essex and beyond

• Feb 16, 2015

• #4

Long since sold mine, but I think it entails having shafts made, can you measure the standard pg1 against one with ird, this will give you the amount to be added

 

DastardlyDan

Active Member

Posts

287

• Feb 16, 2015

• #5

that's what I've just asked for

comparing the installed length from a hippo, to the installed shafts on my Rover 45, will give us a good idea what's needed