Grit Valve
2000 4.6 Vouge
- Posts
- 12,465
- Location
- Plaistow
fuel system help
- Thread starter valhalla
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Brands hatch is where I am .
If possible I would buy it and pay for next day postage , I hired a car til monday so have a few days on my side .
Thanks again .
- Posts
- 58,170
- Location
- Preston Lancs.
The in tank pump will only run with ignition on if engine is cold. It will not run on ignition if engine is hot. 
The in tank pump will only run with ignition on if engine is cold. It will not run on ignition if engine is hot.
cars been sat a week while ive been in spain
- Posts
- 58,170
- Location
- Preston Lancs.
cars been sat a week while ive been in spain
Have you put live from battery to pin 5 of relay 12 to check if relay is duff. Or is that what the AA did? Pump will only run when glow lamp is on.
i havent and not sure about aa guy .
i have swapped relays around to check though and all is fine .
Grit Valve
2000 4.6 Vouge
- Posts
- 12,465
- Location
- Plaistow
The in tank pump will only run with ignition on if engine is cold. It will not run on ignition if engine is hot.
I know that's why I told him to crank as well we've had this conversation before mine only works with cranking the car but we will end that one here
- Posts
- 58,170
- Location
- Preston Lancs.
I know that's why I told him to crank as well we've had this conversation before mine only works with cranking the car but we will end that one here
On pre 1999 cars pump will only run with glows on or with engine running. On post 1999 cars pump runs with glows on, when cranking or with engine running.
- Posts
- 58,170
- Location
- Preston Lancs.
Lets put it this way DON'T use a jigsaw. Personally i would remove tank. You can then check condition of brake pipes that run above it.
dropping tank is not viable , my parking is on the road .
- Posts
- 58,170
- Location
- Preston Lancs.
Then i would suggest a little Dremel type tool with lots of cutting discs. Just barely going through the metal.
stopover
Active Member
- Posts
- 852
I used one of these, made the job easy. Drill-Powered Sheet Metal Nibbler | Frost Auto Restoration Techniques
Any tips of cutting and where to cut also pipes etc to look out for ?
- Posts
- 16,479
Have you not seen the fantastic post by a previous member (search is your friend) he details it down spot on...
EDIT: Try this http://www.landyzone.co.uk/lz/f10/tank-fuel-pump-template-p38-109368.html
EDIT: Try this http://www.landyzone.co.uk/lz/f10/tank-fuel-pump-template-p38-109368.html
stopover
Active Member
- Posts
- 852
http://www.landyzone.co.uk/lz/f10/tank-fuel-pump-template-p38-109368.html
Good luck.
ps Once done, I resealed it around the edges with adhesive/sealant from B&Q that works on most things like metal, wood etc "Serious Stuff" or something like that.
Last edited:
Datatek
Well-Known Member
- Posts
- 44,887
- Location
- Near Poitiers SW France
It's against the law to grind babies, you'll have social services after youPump bought and a baby grinder
It's against the law to grind babies, you'll have social services after you
dont worry if the pump dont fix the problem i`ll burn any baby grindings and the cunting RR
