Freelander 1 Fuel rail pressure sensor harness upgrade

So, I've drilled a hole for the little rubber grommet and removed the plugs from their connector blocks.

I just want to triple check the pin numbers before i go any further....

I've done a little research and the numbers 20, 33 & 35 seem to come up most often. Are these the correct pins for the three wires in the uprated harness?

At present; 20 & 33 are empty and 35 has a yellow/red wire in it.... The haynes manual says that 20, 33 & 35 should have wires in of the same colour as those in the uprated section of harness (wht/yell, blk/blu & whatever the other one is, it's cold outside so i'm not checking).

I'd really like to get this squared away this evening as i have a busy day tomorrow.

Many thanks in advance.

Never mind..... turns out there's more than one plug numbered through the 20s.
Replacing the harness did sweet FA though.

https://www.landyzone.co.uk/land-rover/freelander-td4-fuel-rail-pressure-sensor-harness-tsb.307429/

I did it recently using the TSB received with the sensor and harness and created the above sticky , the tsb is at the bottom of the thread if you want to double check things

Did you change the sensor too?