P38A Front Crankshaft Oil Seal Speedi Sleeve

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
MrGorsky

MrGorsky

Well-Known Member
Full Member
Posts
1,520
Location
Buckinghamshire.
In an attempt to stop the oil leak I've got at my front crankshaft oil seal, I fitted a Speedi Sleeve shaft repair sleeve to my crankshaft pulley today.

If anyone else is suffering constant leaks from the front of the engine, maybe this will sort i for you.

It's too early to say if it's a long term fix, but installing one is dead easy, especially if you've got @Saint.V8 's homemade crankshaft pulley removal tool on hand. Probably a hour and half to do the lot, including re-newing the seal itself.

SKF 99192 is the part I used.
 
MrGorsky said:
Also, after a longish test run, the oil seems to have stopped......for now.
Click to expand...

If v8 Developments had polished the crank before fitting the replacement seal iwhen they rebuilt the engine earlier in the year it wouldn't have failed in under a 1000 miles in the first place. I'm still not impressed with that and wondering how long the rear one will last.
 
Grrrrrr said:
If v8 Developments had polished the crank before fitting the replacement seal iwhen they rebuilt the engine earlier in the year it wouldn't have failed in under a 1000 miles in the first place. I'm still not impressed with that and wondering how long the rear one will last.
Click to expand...
It's not the crank that's the problem, it's the pulley. Polishing wouldn't have removed the groove on the pulley. It always needed a new one, or sleeving. I suppose they might have offered to renew it or sleeve it for me, but the groove isn't that deep (you can't catch your thumbnail on it) so maybe they didn't think it needed it. 350 odd mile run to Devon and back this weekend at a steady 70 mph though and there's no signs of a leak.... Maybe I'm oil tight again, at least until the end of the summer.
 
Last edited:
Got one of those on the crank pulley of my 3.5 Classic for the same wear reason.
And on the input & output shafts of the steering box.
No problems so far - steering box done several years ago & the pulley just before covid.
Used them before on other stuff so no problems

ETA I can't remember the size of the speedisleeve I used on the crank pulley.
Occurred to me that my reply above might make people assume the one the OP used is the same .
 
Last edited:
You must log in or register to reply here.

Similar threads

E
Freelander 1 Fitting new crankshaft rear oil seal and oil sump gasket to L series
Replies
1
Views
491
GrumpyGel
GrumpyGel
P
Oil Leak Between PTU and Auto Transmission - Fitted Incorrectly ?
Replies
6
Views
3K
pete10
P
Frisol
Series 2a Gearbox - retaining compound, grease, and oil seal "compound"
Replies
5
Views
1K
Wildefalcon
W
J
Classic Rover Diff Pinion Seal Depth and Flange Issues
Replies
7
Views
934
Jim_P
J
mad85
Disco 2 TD5 Crankshaft pulley - seal to change or not to change?
Replies
5
Views
2K
mad85
mad85
Back
Top