Disco 2 Front Cossmember Bolts

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
goofy2000

goofy2000

Member
Posts
49
Location
Essex
Morning, I am losing the will I am in the process of changing oil pump bolt and have spent the last two hours trying to get the cross member bolts out. I have been soaking them in WD for the last week etc.
I am frightened I am going to round the heads off using 10 m socket?

Any suggestion getting desperate and cold?
 
Could be worse, the PO of mine welded the cross member in place because 4 of the bolts had sheared.
I had to grind off 4 of the welded blobs, and of the that had bolts in place 2 sheared off, only 2 came out in one piece.
Good luck can be a PITA of a job.

Cheers
 
a 10mm irwin socket, though hit heads of bolts vigorously first as this helps loosen the bolt, but you will need to keep tapping a socket on to keep head from getting too mushroomed
 
If all else fails it is possible to do without taking crossmember off,I had same problem and limited tools at that time of night,needed for work next day so jacked car right up and gained enough room
 
I soaked mine in penetrating oil, pointed a heat gun onto the captive nuts for a few mins and used a good wall drive socket after tapping it down to makd sure it was seated properly. Decent leverage and careful application of pressure they came off quite easily. Did have new ones handy just in case.
 
Hellastony said:
Common problem. Alternatively worst case scenario, grind the bolt heads off, remove the cross member and then with a cold chisel knock the captured nuts off, they come away easily. Simply replace with new nuts and bolts.

Tony
Click to expand...
Would it be possible to use Rivnuts?
Griff
 
Hellastony said:
Common problem. Alternatively worst case scenario, grind the bolt heads off, remove the cross member and then with a cold chisel knock the captured nuts off, they come away easily. Simply replace with new nuts and bolts.

Tony
Click to expand...
Thank you all, I am taking it into work Thursday to do this, got two bolts removed after 8 hours that was only after nipping out and getting some Irwins on them the rest would not move
 
Make sure you have a good quality impact socket set (6 sided rather than the multi points) that way it doesn't put as much pressure on the edge of the bolt and round it off. If you can get an oxy torch on there and get them glowing and they should wind out no problems!
 
Last edited:
ShaneMitchinson said:
Make sure you have a good quality impact socket set (6 sided rather than the multi points) that way it doesn't put as much pressure on the edge of the bolt and round it off. If you can get an oxy torch on there and get them glowing and they should wind out no problems!
Click to expand...
thank you plan is tomorrow heat them up fingers crossed
 
Update thanks for the good advice got there in the end :D. Using a combination of a good socket (Irwin), Heat oxy torch and in the end Grinder for the last two stubborn bolts. Now onto the next job!!
 
You must log in or register to reply here.

Similar threads

L
GETTING SWIVEL TO AXLE BOLTS OUT!! - they are out!!!
2
Replies
29
Views
2K
Forrest Gump
F
A
P38A Head bolt removal question
Replies
6
Views
289
AndyF07
A
A
Wrong bolts?
Replies
7
Views
707
Anaconda
A
xDParis64
Freelander 1 Skid Plate Bolt Sizes + Engine Compression
Replies
19
Views
773
J_D
J_D
A
I'm a bad parent ( indicator issue )
Replies
4
Views
392
Hicap phill
H
Back
Top