Front Axle Half Shaft - Pitted Seal Face

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
ScottyNinety

ScottyNinety

New Member
Posts
9
Location
Aberdeenshire
Thanks for any advice on this one people....

Reassembling front axle and one of the half-shafts has a little surface corrosion and pitting on the machined oil seal face as per the image which I hope shows enough detail.

Is this fit for purpose or should I get it machined or turn in a lathe with some wet or dry get the surface uniform? Or am I overthinking it as usual?

The splines are perfect as it's actually a new old stock item I picked up off eBay but has suffered some corrosion after many years in a cardboard tube.

All guidance appreciated.
 

Attachments

  • IMG_2206.jpg
    IMG_2206.jpg
    158.9 KB · Views: 112
Speedi-sleeve it
They're very good, I've got several on my Classic incl the power steering box output shaft & the front crankshaft pulley.
You'll need a long piece of tube to drive it into place as the driver supplied with the sleeve will be way too short but it is a normal method of fitting it.
Don't be tempted to try & heat one to help fit.
You do need to get it into the right position, potentially you may need 2 butted up to each other.
You use the normal seal.
https://www.skf.com/uk/products/ind...smission-seals/wear-sleeves/skf-speedi-sleeve

When I did the crank pulley I lightly greased the pulley (without the sleeve fitted) & then fitted the pulley to the engine. The seal moved the grease & this ring showed me exactly where I needed to have the sleeve.
I did consider just fitting a replacement pulley - it was well worn - but the prices were eyewatering.
 
Last edited:
Speedi sleeves great things, my series rear output flange has been dry for a couple of years now, before the sleeve and with just a new seal it would stay dry for a week or two at best.
 
When I did mine I had them flame sprayed then just dressed them up on a lathe with some Emery cloth.
 
Good info, thanks all - visited the SKF/Speedi-Sleeve website this morning - brilliant solution!

And I have all the remaining key ingredients...hammers, bit of pipe, brute force and ignorance (plenty) - what could possibly go wrong?
 
You must log in or register to reply here.

Similar threads

julianf
Half shaft oil seal removal ?
Replies
6
Views
291
miktdish
miktdish
proto57
Freelander 2 (LR2) Baffling (to me!) front Half-shaft/Axle Length Mystery! Too short, twice???
Replies
10
Views
858
Zorro587
Zorro587
G
Half shaft seals failing repeatedly Discovery 2
2
Replies
20
Views
1K
Gingerbread
G
B
rear axle
Replies
0
Views
209
bosun
B
dag019
Which stub axle seal do I need?
Replies
3
Views
884
tottot
tottot
Back
Top