Freelander wheels
- Thread starter Ditto12
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
LR state the there must be no more than 5mm difference between front and rear provided the largest go on the rear. 10mm is to much of a difference. This will likely cause the VCU to be over driven which will strain the IRD and rear diff!!
- Posts
- 1,497
- Location
- Somerset (but I'm a Landanna)
Circumference or diameter?
Nodge68
Well-Known Member
- Posts
- 32,504
- Location
- Near Newquay
I assume diameter. 5mm circumference would be unmeasurable.
- Posts
- 1,497
- Location
- Somerset (but I'm a Landanna)
Ok, just that Ditto said the 10mm difference was in the circumference, which would be equivalent to a 3mm diameter difference, so probably ok then 
