Freelander TD4 2005
- Thread starter JC600
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
JC600
Well-Known Member
- Posts
- 1,103
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
JC600
Well-Known Member
- Posts
- 1,103
JC600
Well-Known Member
- Posts
- 1,103
The Freelander went my brothers work today, for oil & filter change, drop link replaced, new pollen filter, 4 X Toyo Proxes CF2 suv tyres and front pads & disc's.
Haven't driven it yet, as I'm on call. Brother picked it up and dropped it off. Said it drove loads better on the Toyo tyres. And the knocking noise has gone. Also 70 mph steering wobble knock, now the warped disc's are in the bin.
Haven't driven it yet, as I'm on call. Brother picked it up and dropped it off. Said it drove loads better on the Toyo tyres. And the knocking noise has gone. Also 70 mph steering wobble knock, now the warped disc's are in the bin.
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
Light guards have arrived, I'll get them fitted at the weekend.
JC600
Well-Known Member
- Posts
- 1,103
Diesel Do
Well-Known Member
- Posts
- 5,213
- Location
- Nottingham
No you won't 
JC600
Well-Known Member
- Posts
- 1,103
Picked up a new Bosch maf sensor today, and fitted after work.
All fitted
Cheap ebay knock off sensor, no manufacturers markings whatsoever.
Went out for a test drive, and was worse to start with. Then went intermittent, then seemed ok driving back into my estate. Think the cheap ebay tat has thrown the ecu values right out. So my brother is bringing the Snap-on diagnosis tool round tomorrow night to clear any old codes, and reset all the values.
All fitted
Cheap ebay knock off sensor, no manufacturers markings whatsoever.
Went out for a test drive, and was worse to start with. Then went intermittent, then seemed ok driving back into my estate. Think the cheap ebay tat has thrown the ecu values right out. So my brother is bringing the Snap-on diagnosis tool round tomorrow night to clear any old codes, and reset all the values.
JC600
Well-Known Member
- Posts
- 1,103
Well the Freelander is driving worse with a new genuine Bosch maf sensor fitted, had the snap on machine on it tonight. No codes at all, whilst driving everything was within parameters except air mass, was in parameter but only going up to 350 (parameter is between 350-3500 approx) . Went down to his work and put it on the Delphi and the same. Left it down there now, he's going to leave the battery disconnected all day, then take it for a test drive. See if the ecu relearns it's values. If not, I don't know. Hopefully his mechanic will find the fault.
td4van
Well-Known Member
- Posts
- 1,566
- Location
- Gloucestershire
There's a reset on T4 for the adaptions for MAF
Not sure of any other way to reset them - might be on the snap on kit
Not sure of any other way to reset them - might be on the snap on kit
JC600
Well-Known Member
- Posts
- 1,103
Hi mate, there wasn't one on Snap-on or Delphi. I know a couple of independent garages with T4. Cheers.
But it's getting there, it's dangerous to drive at the moment.
Going to check the map sensor too, as this seems to be a common faults along with the maf.
JC600
Well-Known Member
- Posts
- 1,103
Well I've cleaned out the intake, map sensor hole was blocked. In the intake and sensor. Dried it all out, refitted still the same and no codes. Map sensor is only 3 months old, and new correct Bosch maf fitted. So going to run with maf disconnected for now, as it runs spot on with no smoke or any loss in power.
JC600
Well-Known Member
- Posts
- 1,103
Picked up some rear mud guards today for £15, whilst I was there noticed it had a power socket so got that too for £5.
Stopped at the range in Stockton and my old Freelander was there.
Still looked well looked after, looked like the lift kit had been removed and standard size tyres but still looked good.
Also made me want a black soft nudge bar and spot light kit.
As my Freelander doesn't have fog lights, I ordered the fog light kit rather than the long range spot lights. Looks like less wiring and only £29.99 Land Rover dealer clearance.
VUB500960
Just need to get the nudge bar now.
Stopped at the range in Stockton and my old Freelander was there.
Still looked well looked after, looked like the lift kit had been removed and standard size tyres but still looked good.
Also made me want a black soft nudge bar and spot light kit.
As my Freelander doesn't have fog lights, I ordered the fog light kit rather than the long range spot lights. Looks like less wiring and only £29.99 Land Rover dealer clearance.
VUB500960
Just need to get the nudge bar now.
Similar threads
