nick the gin
Member
- Posts
- 91
- Location
- tunbridge wells
has anyone rebuilt a sunroof motor freelander 1 2002 pre facelift cant find a vid anywere ?tia
freelander 1 sunroof motor
- Thread starter nick the gin
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
GrumpyGel
Well-Known Member
- Posts
- 26,386
- Location
- Christchurch, New Zealand
Has the motor died or just the little plastic cog?
Might be easier to get 1 from a breakers.
- Posts
- 3,878
- Location
- Near Heathrow.
I have been searching for the same info, but cannot find anything.
So having bought on eBay what I though was the correct part, today I decided to drill out the rivets & see if I could sort the metal gear. It's a bit small to attempt on my press, and not sure if the two gears actually come apart. The plastic cogs inside the gearbox are fine.
Pic 1 is what 99% of sellers are showing online.
Pics 2 & 3 are what is actually fitted to the sunroof motor.
So having bought on eBay what I though was the correct part, today I decided to drill out the rivets & see if I could sort the metal gear. It's a bit small to attempt on my press, and not sure if the two gears actually come apart. The plastic cogs inside the gearbox are fine.
Pic 1 is what 99% of sellers are showing online.
Pics 2 & 3 are what is actually fitted to the sunroof motor.
andyfreelandy
Well-Known Member
- Posts
- 5,561
- Location
- Devon
The 2 cogs prise apart, I reinstalled between 2 small sockets in the vice.
andyfreelandy
Well-Known Member
- Posts
- 5,561
- Location
- Devon
Solved the clicking when closed or fully open. There is no cut off switch, when you reinstall there is a procedure in RAVE to make sure the tilt then stop and then slide back work OK.
- Posts
- 3,878
- Location
- Near Heathrow.
Yes eventually figured that out after getting the motor apart. There wasn't room to get anything between the two, so I used a large nut on one side for support, and small nut against the stub. Then pressed them apart in the vice.
Motor re-assembled using self taps, but after a while the metal cog popped out a bit & disengaged with the cables. Suspect it's loose in the plastic inside, which did have some cracks in it
. Guess it's either motor replacement time or seal the glass shut & unplug everything !!.Did you end up fixing it? My sunroof has been busted for a few years, sounds crunchy when button is pressed and leaks water. Suspecting the cog has degraded and broken and thus it can't fully close and seal so water is slowly getting in.Yes eventually figured that out after getting the motor apart. There wasn't room to get anything between the two, so I used a large nut on one side for support, and small nut against the stub. Then pressed them apart in the vice.
Motor re-assembled using self taps, but after a while the metal cog popped out a bit & disengaged with the cables. Suspect it's loose in the plastic inside, which did have some cracks in it
Struggling to find a regulator/motor replacement so tempted to seal and unplug like you say.
- Posts
- 3,878
- Location
- Near Heathrow.
The leak on my Son's FL1 was corrosion around the glass frame, plus lots of mouldy growth arounbd the roof aperture (due to the leak). We ended up grabbing a complete sunroof assembly on eBay, which was then stripped to make a good one out of the two. Did the motor and the sliding gears at the same time, plus used Kurust & resprayed the frame as well.
Have you checked / cleaned the drains that run down the A pillar?
