Footwell replacement

lofty69

Active Member

Posts

170

• Aug 12, 2013

• #1

My footwells are in need of some welding and I'm wondering if it's best to just replace the whole things? If I do replace them can these be welded with the bulkhead still attached or is it best for them to be done with the bulkhead off?

I've made a start on stripping out the dash so taking the dash out isn't an issue, would just rather not have to take the bulkhead off.

Cheers

 

BearDy89

Well-Known Member

Posts

1,518

Location

Bristol

• Aug 12, 2013

• #2

Mine need doing as well.

Will be interested in the replies!

 

Kev@kenninghall

Well-Known Member

Posts

902

Location

Norfolk

• Aug 12, 2013

• #3

I've just patched mine, in situ, by hacking a yrm footwell and cutting out the rotten bit. However, it's only a temp fix for me while I save up to have the bulkhead refurbished, although I am starting to think about doing the job myself.

Can't afford a rear crossmember and bulkhead in the same month

 

muckmuck

Active Member

Posts

798

Location

chatteris cambridgeshire

• Aug 12, 2013

• #4

Recently did my footwells,was going to buy the replacements ,but once I cut the rusty bits out and cleaned them up ,they wasn't actually too bad so got away with welding a plate in

 

J

johnson1234

New Member

Posts

37

• Aug 12, 2013

• #5

I replaced mine with DA6100 & DA6101 bit of a pain to replace them but was worth it. Not that expensive either.