ffs!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Ordered it from Jake Wrights Wednesday, picked it up today at 10:30 - quick service! Really need to do more revision
 
I'm really having trouble getting the tank to drop out from the chassis. Have just spent 2 hours trying to force, stamp, smack and prise it outwith my Dad but to no effect. How the hell does the bugger come out? We haven't taken the floor up (but everything is loose and undone), it just keeps getting stuck.

Thanks for any more advice!
-Pos
 
what end of yer dad did yerr use? either way it dint matter, make sure all the pipes are orf and that the filler neck int sticking , then instead of using yer dad try a crowbar or other metal lever
 
cheers Slob,

The lip on the side of the tank just wont drop down the side of the chassis rails. Don't know what we're doing wrong
 
The thing is the lip of the tank sits above the chassis rail so you have to tilt the right hand side of the tank down, this causes the top right hand corner bit of the tank to foul against the sill. If you think getting the old un out is hard wait till yer try putting the new un in,cos you won't want to damage it.
 
We've done it! :D

Managed to get the old tank out with a bit of brute force and the new one went in quite a bit easier actually (didn't take the floor up). I just put the back end in first and then jacked the front up. it lifted the car a little but but it eventually "popped" into place! New stainless steel nuts and bolts and a coat of waxoyl on the bugger too so all is well that ends well.

Thanks very much for the help and advice!
Just hope that I wont have to do that again.

PS. Just out of interest, is it easier or harder than replacing the fuel tank to take the gear box out or replace the clutch? (just for reference sake)

Cheers
-Pos
 
GRUNT said:
Fathers lost a couple of fingers though.

Gearbox an transfer box is a piece of **** compared to the tank, mine dint go back in owt like as easy as yours.
Click to expand...

Hehe, no neither of us have cuts or bruises. My Dad banged his head on my door on one occasion :eek: We managed to get the tank in almost straight with the lip half up the side of the chassis and I could see that it was right back to the two mounting points and it had cleared the seat box so up it got jacked and in it went
 
You must log in or register to reply here.

Similar threads

G
300Tdi coolant issue
Replies
2
Views
478
GilesHarrison
G
B
Driverside seat mount
Replies
4
Views
256
meego
meego
tweedandbriar
Flat Spot at low revs...
Replies
4
Views
275
tweedandbriar
tweedandbriar
stumpyj
Fuel Line worn through
Replies
2
Views
558
stumpyj
stumpyj
swmeader
Fuel primer
Replies
10
Views
1K
dag019
dag019
Back
Top