Everything Dead

Skolmate · Feb 7, 2018

nobber said:
Time to visually inspect and electrically check some wires then fella, this might help but a wiring diagram would be much better, should be one on tinternet for your vehicle, you will defo need a diagram, just go methodically , you know whats broke, you just need to find out where.

http://www.expeditionlandrover.info/Lucaswirecode.htm

Edit, always a good idea to extend the meters wires when checking for continuity , especially when a wire starts in the dash and ends in the engine bay.

Thanks pal. To extend the multimeter cables can I just cut and splice more wire in?

K14 · Feb 7, 2018

Start with checking the basics / bigger high current carrying cables and earth straps. Then focus on individual circuits. You will need a wiring diagram and multi meter. You will find the fault with methodical process of elimination. Don't (as some people do) randomly rip you car to bits, hoping the fault will jump out at you

nobber · Feb 8, 2018

Skolmate said:
Thanks pal. To extend the multimeter cables can I just cut and splice more wire in?

I wouldn't be that drastic , no , Do you have any crimp terminals, surely you could make something up without cutting up your leads?

flat · Feb 8, 2018

Skolmate said:
Thanks pal. To extend the multimeter cables can I just cut and splice more wire in?

I brought longer wires on eBay so I had 2 sets - shorter ones for normal stuff and then the longer ones for real arms length stuff, they were only a few quid and are a metre or so long

Flossie · Feb 8, 2018

My mm came with leads that I can screw insulated croc clips into, that's a useful thing to have too.

Flossie · Feb 8, 2018

nobber said:
I wouldn't be that drastic , no , Do you have any crimp terminals, surely you could make something up without cutting up your leads?

If they are the probe type? Chocy block to extend maybe?

Skolmate · Feb 11, 2018

Right so constant live (brown) had melted and had touched the large and small red/brown cables all at the back of the ignition switch. No fuses in the fuse box blown, where abouts is the 60a fuse on the 200tdi 110? I think this must have blown cause after separating still wouldn't start. Taken out the scorched melted section of cable, planning on replacing and putting back together. I did find a brown and red cable that had been taped up in the engine bay. The tape had come loose and it is possible the exposed end touched the block. Would this have caused this?

Everything Dead

Skolmate

Active Member

K14

Well-Known Member

nobber

Well-Known Member

flat

Well-Known Member

Flossie

Well-Known Member

Flossie

Well-Known Member

Skolmate

Active Member

Attachments

Similar threads