Engine wire harness help - Wire hook up?

P38 Yank · Aug 20, 2014

Hi, I'm finishing up my motor to put back into the truck. I have to wires with ring terminals that need final placement. :whoosh:
They both appear to be grounds with ring terminals crimped on them that would likely be fixed under a bolt or nut. One wire is black on dipstick side. Other wire is red on oil filler neck side. The wire reach coil bracket and fuel rail mounting bolts. So, I'm assuming that they hook up under either of these barackets? I looked through RAVE with out much luck. I'm hoping someone on this site has some knowledge of were these hook up. I attached a couple of photos for reference. Please help it is one of the last problems I need to tackle before installing the motor.

P38 Yank · Aug 20, 2014

Help?

tomcat59alan · Aug 20, 2014

P38 Yank said:
Help?

Would love to Yank but I'm a diesel man, there must be a petrol head that can nip outside and have a look under the bonnet (hood) for you.

wammers · Aug 20, 2014

It is very doubtful that the red wire is a ground. Must power something. Black wire will be a ground.

ukadamwest · Aug 21, 2014

I'll pop the hood and take some photos of my 4.6 engine in those locations and post them up for you. (my block wont be as clean as yours though)

ukadamwest · Aug 21, 2014

Cant see jack on mine too much in the way of accessories in the way, which engine and model year is yours ?

Druim · Aug 21, 2014

Had a good look, cannot see any of those wires in that location on mine, as Adam said, hard to get to area

Sorry not much help

Engine wire harness help - Wire hook up?

P38 Yank

New Member

Attachments

P38 Yank

New Member

tomcat59alan

Well-Known Member

wammers

No longer with us, RIP

ukadamwest

Well-Known Member

ukadamwest

Well-Known Member

Druim

Well-Known Member

Similar threads