Shimsteriom
Master Procrastinator
- Posts
- 41,905
- Location
- Over Here
Engine roughness resolved
- Thread starter Discodevon
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
neilly
Well-Known Member
- Posts
- 20,000
- Location
- Oxfordshireness
What I like about one of those adverts is,
Not, It is advertised as Stainless steel and then in the blog below it states Aluminium....... not sure \i trust them TBH.... If I needed to do it a quick skim and maybe a deweb if I could be bothered.
Cheers
Not, It is advertised as Stainless steel and then in the blog below it states Aluminium....... not sure \i trust them TBH.... If I needed to do it a quick skim and maybe a deweb if I could be bothered.Cheers
bankz5152
Well-Known Member
- Posts
- 9,339
- Location
- South London/North Kent
Yeah, fitted it friday. My EGR blank was leaking and couldnt get the bolts out, so manifold off. No broken studs!
Previous manifold wasnt warpped but had a dewebbed one sitting around. Refitted with copper flashed nuts so its easier to get off if need be.
I was looking at those aswell. Too cheap imo
Bobdog
Well-Known Member
- Posts
- 4,286
- Location
- Horsham West Sussex
I was just browsing the threads and came across this one. So i checked mine. I've thought for a while my engine seems just slightly rough but not down on fuel ecomomy or noticeable power loss. I have had what sounds like one of those old policeman's whistles going on under load but only barely noticeable. Anyway, lo and behold- the front lower stud is missing. No sooty deposits around the manifold but then its a bit dirty anyway, nothing extra though. Running fine for now, so one for the to do list.
Still..... ARSE!!
Still..... ARSE!!
Similar threads
