Disco 1 Engine rotate with cylinder head removed
- Thread starter mr glee
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
freelance
Well-Known Member
- Posts
- 8,685
- Location
- essex and beyond
It all looks as it should and yes you can rotate without affecting cam followers, is there any sign of gasket damage?
ceffyn
Active Member
- Posts
- 418
- Location
- Aberdare - South Wales
shouldnt the water channels on the bottom be open and clean! and as for rotating the engine with the head off jack up the one wheel (i do driver side but not for any reason) put it in 5th gear and turn the wheel, that will rotate the engine nice and easy for you 
Gazbo
Well-Known Member
- Posts
- 3,949
Without the head on the engine you should be able to rotate the engine by hand on the crank pulley, or if it's a little tight, a socket spanner on the crank pulley bolt head.
Head now off to be pressure checked and if needed skim.did look at new heads and now see it's just corrosion eating into it.no obvious sign of damage to head gasket tho all bolts where we'll worn had to force undersized socket on 3 of them and a couple went lose as soon as I cracked them.head gasket also lifted off with out leaving half of it behind never had that before.
Gazbo
Well-Known Member
- Posts
- 3,949
A full new set of headbolts should be used to replace the head, the bolts are tty (torque to yeild), and do not allow reuse more than maybe twice, sounds as though your current head bolts may be past their service life and have stretched.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
new head
Similar threads
