Engine pressurised?

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

S3hooke

Active Member
Posts
125
Location
Exeter, Devon- come say hi!
So a new seal on the rear crank and start up, drive a bit (new engine to me- 4 years in a field prior to my picking up)

Oil piddling out the back, but it's a new seal?! Also oil Flies out when we removed the oil dipstick at about 2000rpm.

Will do a compression test bo see about piston rings- but is there anything else it could be? Is it normal to have oil spurting out at 2k revs from the dipstick?

Thanks for any help!
 
To be honest, it sounds like the engine is heavily worn, 1 or more of the pistons could be cracked which would cause a huge amount of Crank Case Pressure and that pressure will find anyway to get out of the crankcase, pushing oil seals out and pushing the dipstick out. It could just be the rings but by the sound of it, the pistons are cracked, sorry mate. I rebuilt my 19J, only cost £100 but you have to know what you are doing, i'm in the trade so thats not a problem lol

Good luck, contact me if you need help :)
 
have you a leak in the vac system ,if theres leak in pipe servo etc it pumps air into block ,but they are very prone to bore and ring wear ,there are no internal breathers oil and air can go fron top to bottom thru large apetures in cam gallery,whats it like with oil filler cap off
 
Last edited:
Ahhhhhhhhhhh is that it?? It's an old landy and we left vac pump open. Old brakes you see. So that could be it?! If so bung it up?? If compression test is correct this could be the problem.......
 
should be blocked it sucks and blows into cam gallery ,but obviously it doesnt if fitted correct as it just pulls a vacuum ,but if open is just an air pump
 
Back
Top