Peter Knaggs
New Member
- Posts
- 8
- Location
- Basingstoke
Looking for recommendations for someone to fit a new engine loom as mine was a little cooked due to a faulty sensor, Im in the Basingstoke reading area, I can come to you or mobile....help please.
L322 Engine loom fitting
- Thread starter Peter Knaggs
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Peter Knaggs
New Member
- Posts
- 8
- Location
- Basingstoke
Or repair it. Engine coolant sensor fried and melted its wiring.
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
What vehicle are you looking at ?
Peter Knaggs
New Member
- Posts
- 8
- Location
- Basingstoke
L322 4.4 v8, I'm hoping for just a repair instead of a full loom swap.
Bemble
Well-Known Member
- Posts
- 652
- Location
- Lancashire
When mine went I just replaced the 20cm or so of the two melted wires and the connector, plus a new thermostat assembly.
Phil
Edit : assuming that you meant the thermostat heater rather than the coolant sensor
Phil
Edit : assuming that you meant the thermostat heater rather than the coolant sensor
Last edited:
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
Your other option is to fit the 80 degree c mod and you won’t need the wires as long as they aren’t shorting out just tuck them away.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
80 degree C mod?
holidaychicken
Well-Known Member
- Posts
- 4,014
- Location
- Kent
80 Deg thermostat mod, the new housing doesn’t have the connector if we are talking the same connector , as in the one that heats the thermostat
