Freelander 1 Engine guard bolts/screws can i get them any one got any?

tlo

Active Member

Posts

558

Location

nottingham

• Nov 11, 2018

• #1

Not sure if this is the right place to post this but can you tell me can these be still had? i have looked on ebay but can not find any . Failing that would any of you guys have any knocking about ? thanks

 

Nodge68

Well-Known Member

Posts

32,848

Location

Cornwall

• Nov 11, 2018

• #2

Which size it it you need?
The 6 or 8 (year depending) main bolts are M10 X 25mm long with a built in washer and 13mm spanner size.
The 2 rear bolts are M6 X 20mm again with a built in washer but with a 10mm spanner size.
Both of these will be available on EBay for not much.
However LR used a small spanner size than normal for there bolts, so generic replacements will need a larger spanner. This is an advantage when it rusts up.
Both sizes are available from here.
https://www.ebay.co.uk/itm/FLANGED-...hash=item545a62632b:m:mFVA5YMCm9fWeyeJ4uex7Ug

 

tlo

Active Member

Posts

558

Location

nottingham

• Nov 11, 2018

• #3

Thanks nodge i have 8 bolts on mine, i need one of the bolts that hold the cover on the side (two each side) and a couple of screws that hold the front valance to the cover

 

Last edited: Nov 11, 2018

Nodge68

Well-Known Member

Posts

32,848

Location

Cornwall

• Nov 11, 2018

• #4

The front screws are 4mm IIRC. I'll measure mine, when I get a chance. Those won't be expensive and could likely be found in Halfrauds.

 

Philgt50

Well-Known Member

Posts

262

Location

Bournemouth

• Dec 15, 2018

• #5

There are some great threads on how to make a better sump guard yourself where you can change the plastic tray to metal (I used a bit of Chequerplate or something) then you only have to drop the plate off and can leave the 13 or something bolted frame in place. I think Alibro May have done it. Definitely pictures somewhere.