I am sure this will have been asked before, but can't find the thread. Rear o/s air bag does not inflate even when triggered with the Nanocom. The compressor goes off, and the rest of the three bags inflate and deflate. First thought was hole in bag, but that can't be right. What am I missing?
EAS one corner down
- Thread starter BigJessie
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Mukiwa
Well-Known Member
- Posts
- 472
- Location
- Winsford, Cheshire, near Oulton Park
Use soapy spray to check for leaks, otherwise a block refurb as it could be a worn out / leaky bit in the EAS block. Mine took 4 hours the other day, but I hadn't had to do one for 5 years, so I was slow.
- Posts
- 3,877
- Location
- Near Heathrow.
+1 on check for leaks. Also check if the solenoid for that corner is actually triggering in the valve block. With your Nanocom connected & ignition on with engine off, you should hear the solenoids click when you activate them.
If one is not operating the bag will not inflate !!
Most likely causes are either bad input connection to the driver pack, or bad connection between the driver pack & solenoids.
If one is not operating the bag will not inflate !!
Most likely causes are either bad input connection to the driver pack, or bad connection between the driver pack & solenoids.
Datatek
Well-Known Member
- Posts
- 44,883
- Location
- Near Poitiers SW France
Take the silencer out at the back of the valve block and see if it is full of white powder.
