- Posts
- 12,634
- Location
- Sud ouest France !
when doing your block refurb,take good look at your nrv's, especially if they are the original ones!! 
P38A EAS jumping around
- Thread starter Wazzajnr
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Update, resetting the values by measuring to the arches seems to have stopped the bouncing around. Only had a couple of short sections at motorway height but I think it's cured it
I don't think it's spot on as the handling doesn't seem quite as good as it was but good enough for now.
I'll be making up some blocks when I get home to set it correctly. (30mm dia nylon is 27 quid a meter from rs components so I'll be ordering a couple of lengths of that)
Thanks again for all the help. This forum is fantastic!
I don't think it's spot on as the handling doesn't seem quite as good as it was but good enough for now.
I'll be making up some blocks when I get home to set it correctly. (30mm dia nylon is 27 quid a meter from rs components so I'll be ordering a couple of lengths of that)
Thanks again for all the help. This forum is fantastic!
brianp38dse
Well-Known Member
- Posts
- 20,067
- Location
- heathrow
Just use some timber, cut to length, its not an item you will be using that often.
I did actually think of a broom handle but not sure what the diameter would be so I just thought I'd buy the nylon from RS. If anyone else needs them then, I can lend them out.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
Broom handle fine. Bit of dowel will do. Mine are a tad thin but work. Amazing stuff wood.
brianp38dse
Well-Known Member
- Posts
- 20,067
- Location
- heathrow
