EAS help!!

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
So I did have just the rear end working and the front not lifting now I only have the passenger side working and drivers side stuck
 
If you have had a bad connection on the rear pipe and its been leaking then there is a good chance your pump is tired, for what it costs for a pump refurb kit do it and hen its a known item, you can check output from pump by undoing the blue pipe from pump and holding your finger over it, if you can pump gone. P39spares on fleebay is a known good supplier of kits.
 
brianp38dse said:
If you have had a bad connection on the rear pipe and its been leaking then there is a good chance your pump is tired, for what it costs for a pump refurb kit do it and hen its a known item, you can check output from pump by undoing the blue pipe from pump and holding your finger over it, if you can pump gone. P39spares on fleebay is a known good supplier of kits.
Click to expand...
Wayne890 said:
I had the back working and only the passenger side is working? Maybe i do have a problem with the valves on the valve block?
Click to expand...
Back always raises first.
It's not likely to be valves in the valve block but as you had a leak, the pump is probably knackered
 
Pump is only running for a second or two at a time. If I turn it on with the software it will run for maybe a second then you can hear it fade out and stop like the power has been cut from it. Pump problem or coil there be another part causing the pump to stop?
 
There is the thermal cut out in the pump?
Unless the tank is full of air?
A faulty pressure switch?
When the pump stops, is it very hot after the short time it runs?
 
Mark Piercy said:
There is the thermal cut out in the pump?
Unless the tank is full of air?
A faulty pressure switch?
When the pump stops, is it very hot after the short time it runs?
Click to expand...
Pumps got very hot when it failed but it’s not running long enough now to get hot. Can the thermal cut out get stuck is there a way of resetting it? I don’t think the tank is full it’s like the power is being cut from the pump it starts when I turn it on with the software but then fades out like it’s lost power and slowing down rather stopping while it’s running
 
Wayne890 said:
Pumps got very hot when it failed but it’s not running long enough now to get hot. Can the thermal cut out get stuck is there a way of resetting it? I don’t think the tank is full it’s like the power is being cut from the pump it starts when I turn it on with the software but then fades out like it’s lost power and slowing down rather stopping while it’s running
Click to expand...
The rear bearing has been known to fail and seize.
 
You must log in or register to reply here.

Similar threads

B
P38A P38 EAS SOS
2
Replies
29
Views
1K
Mark Piercy
Mark Piercy
J
P38A p38 EAS - immediate drop of pressure
Replies
11
Views
605
Mark Piercy
Mark Piercy
pwood999
P38A Asthmatic EAS Exhaust Port !!
Replies
6
Views
640
pwood999
pwood999
ar1g3
P38A Which EAS repair kit to get?
Replies
18
Views
1K
Grrrrrr
Grrrrrr
Flossie
P38A Eas issues
2
Replies
22
Views
1K
Datatek
Datatek
Back
Top