YankeeLandee
Member
- Posts
- 68
- Location
- Northampton
Well this is my first post actually showing how and what I've been doing. Since it's Saturday night and I'm half asleep, I'll most likely have to update or edit this post in future replies.
On to the photos:
This is what i started with. I already cut the ends off and split it down the middle to help me get it out. I used a screw driver to flip the lip up and it didn't create any damage. Luckily.
And then....
With the new installation of the power door lock actuator, I had to move it before I started to chop everything up. The rusted door pieces looked like a damn Pillsbury ready dough can after use. So I had to cut a little higher than expected.
Closer view :
To be continued... Thanks for reading. Any observations/advice (the sole reason I post **** here) Is greatly appreciated! Cheers! I promise I'll get better at "blogging" my how to's. Sorry for the massive photos too.
On to the photos:
This is what i started with. I already cut the ends off and split it down the middle to help me get it out. I used a screw driver to flip the lip up and it didn't create any damage. Luckily.
And then....
With the new installation of the power door lock actuator, I had to move it before I started to chop everything up. The rusted door pieces looked like a damn Pillsbury ready dough can after use. So I had to cut a little higher than expected.
Closer view :
To be continued... Thanks for reading. Any observations/advice (the sole reason I post **** here) Is greatly appreciated! Cheers! I promise I'll get better at "blogging" my how to's. Sorry for the massive photos too.
Last edited:
