Do I need a new driver pack

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
Reight had to run wife to her sisters so put Hawkeye on with live diagnostics to compare with the plugged in ciggy thing. hawkeye showing 13.8volts with engine running ciggy voltage 12.8. After 5 miles Hawkeye 13.7 other 12.6.
 
Rubberknees said:
Thanks will get it tested. Could it be the cause of my problems
Click to expand...
Sounds like a waste of time testing it, I suspect the brushes are worn out and in any case the regulator it's incorrect for modern batteries. It's easy enough to swap the regulator, comes with new brushes, can be done with the alternator in situe but easier with the alternator off the car the first time.
 
Datatek said:
Sounds like a waste of time testing it, I suspect the brushes are worn out and in any case the regulator it's incorrect for modern batteries. It's easy enough to swap the regulator, comes with new brushes, can be done with the alternator in situe but easier with the alternator off the car the first time.
Click to expand...
Do you have a good link to where I can get one from please
 
Bit of advice please. When putting new regulator on do I leave the cover holding brushes in place until its fitted or do I take it off first and then fit. Thanks in advance
 
You must log in or register to reply here.

Similar threads

B
P38A 1996 4.6 Auto HSE. driver side bags not inflating after valve block rebuild.
Replies
17
Views
1K
nigelbb
N
B
P38A P38A 1996 4.6 Auto HSE EAS slow to lower and rise + random height change to extended height + compressor running too frequently.
Replies
9
Views
1K
Datatek
Datatek
Montyjohn
P38A A couple of queries about rebuild EAS valve block
Replies
9
Views
1K
Grrrrrr
Grrrrrr
pwood999
P38A EAS Random Extended Mode Selection
Replies
16
Views
1K
Datatek
Datatek
8v_chris
Air leak detection - EAS woes!
2 3
Replies
52
Views
7K
j38
J
Back
Top