Klm2
New Member
- Posts
- 65
- Location
- County Durham
Hi all
can any one point me in the right direction?
Just spent a few hours under the bonnet with a tickover issue and noticed a "spare wire" flapping in the breeze.
Traced it back to a sensor on the right hand side of the block (looking from the front) and located just next to the oil filter. The sensor has one of those "push there spring to remove" connectors. However upon removal 2 issues were noted:
1) there is only one cable in what should be a 2 cable connector
and
2) the cable that is there is not connected to anything.
So the questions I have are :
a) what is this sensor "sensing"
b) should there be 2 cables
c) where should they be connected to
and
d) if they are not "sensing" shouldn't I have a warning light on ???????
Once again, thanks in advance....
Your expertise is very much appreciated.
can any one point me in the right direction?
Just spent a few hours under the bonnet with a tickover issue and noticed a "spare wire" flapping in the breeze.
Traced it back to a sensor on the right hand side of the block (looking from the front) and located just next to the oil filter. The sensor has one of those "push there spring to remove" connectors. However upon removal 2 issues were noted:
1) there is only one cable in what should be a 2 cable connector
and
2) the cable that is there is not connected to anything.
So the questions I have are :
a) what is this sensor "sensing"
b) should there be 2 cables
c) where should they be connected to
and
d) if they are not "sensing" shouldn't I have a warning light on ???????
Once again, thanks in advance....
Your expertise is very much appreciated.
