Disco 1 swivel pin

A

Anaconda

Well-Known Member

Posts

3,550

Location

Thames Valley

• Nov 15, 2024

• #1

My son has a Disco 1 front axle with the short stubby drive shaft inside the hub cover/flange.
Does anyone have a link to the correct top swivel pin and shims.
Many thanks.

 

D1Nut

Well-Known Member

Posts

395

Location

South Africa

• Nov 15, 2024

• #2

Not a link but from my D1 workshop manual - Never had to use this section before

 

Attachments

• D1_Workshop_Manual (1).pdf

  492.4 KB · Views: 34

A

Anaconda

Well-Known Member

Posts

3,550

Location

Thames Valley

• Nov 15, 2024

• #3

Thank you, it's slightly different to the example in the pdf, but I should think the top swivel pin is the same.
This maybe unless anyone knows any different.

Upper swivel pin - 571756

571756 Upper swivel pin

www.paddockspares.com

 

discool

Well-Known Member

Posts

13,608

Location

Sector 12 in Kent, The Garden of England

• Nov 15, 2024

• #4

Anaconda said:

Thank you, it's slightly different to the example in the pdf, but I should think the top swivel pin is the same.
This maybe unless anyone knows any different.

Upper swivel pin - 571756

571756 Upper swivel pin

www.paddockspares.com

Click to expand...

U have the correct part number.
The shims depending on their thickness, are 751743 or 44 or 45 or 46.

 

KiwiTDI

Active Member

Posts

202

• Sunday at 06:57

• #5

I cant remember if its the top or bottom swivel bearing but one (i think the top) is different because the ABS sensor goes through it, obvnot a factor unless you have ABS

 

discool

Well-Known Member

Posts

13,608

Location

Sector 12 in Kent, The Garden of England

• Sunday at 12:31

• #6

KiwiTDI said:

I cant remember if its the top or bottom swivel bearing but one (i think the top) is different because the ABS sensor goes through it, obvnot a factor unless you have ABS

Click to expand...

The ABS was fitted/option for the 300 series D, so as the OP has done his research and given a part number confirmed in the attached link we can assume that their post relates to the 200 series.

 

A

Anaconda

Well-Known Member

Posts

3,550

Location

Thames Valley

• Thursday at 19:26

• #7

Well, who would have thought it?
I already have the shims in stock, tiny bit of play in one side. Want to put off the inevitable for a while, if there is any shims on the top pin at the moment.