Dip beam and sidelight not working

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.

T90DGG

Member
Posts
14
I replaced a fuse to make the near side, side light work again. But seem to have blown the dipped & side lights on both near and drivers.

The full beams work but only if i pull back the indicator stalk.

Could this be the light switch on the column?
I am guessing that there is some short circuiting in the car as this is not the first blown fuse issue?
 
what year and model later models have l lighting relay controlling the main and dipped beams which are also fused.
the side and tail are also fused separately the horn and flash are also separately fused so would check before replacing any items
 

Attachments

  • 1999 DEFENDER LIGHTING.png
    1999 DEFENDER LIGHTING.png
    222.3 KB · Views: 127
what year and model later models have l lighting relay controlling the main and dipped beams which are also fused.
the side and tail are also fused separately the horn and flash are also separately fused so would check before replacing any items
I am a 2002 TD5
 
test the input voltage on 30 and the output voltage on 87 and check the resistance for short to earth I'm not a great fan of link's unless there is a fuse in the link. swapping the relay for the same is another as the fault that may have destroyed the original may do the same to the replacement ,or be the catalyst for a dash fire if the cabling was or is damaged its time to breakout the DVM
 
test the input voltage on 30 and the output voltage on 87 and check the resistance for short to earth I'm not a great fan of link's unless there is a fuse in the link. swapping the relay for the same is another as the fault that may have destroyed the original may do the same to the replacement ,or be the catalyst for a dash fire if the cabling was or is damaged its time to breakout the DVM
I have tested the fuse in the box and swapped with a known working fuse and replaced the light switch but has not fixed the issue.

Could it be the function box in the drivers side wing?
or the full light stalk?
 

Attachments

  • Defender Stalk.jpg
    Defender Stalk.jpg
    528.5 KB · Views: 117
  • Light Switch.jpg
    Light Switch.jpg
    478.8 KB · Views: 101
  • New Light Switch.jpg
    New Light Switch.jpg
    642.4 KB · Views: 106
I have tested the fuse in the box and swapped with a known working fuse and replaced the light switch but has not fixed the issue.

Could it be the function box in the drivers side wing?
or the full light stalk?
Have you bridged the contacts to isolate the stalk. I had the same symptoms which led to removing every piece of wire, headlights, and and and very annoying until a kind member on here suggested the stalk as the likely issue.
 
Have you bridged the contacts to isolate the stalk. I had the same symptoms which led to removing every piece of wire, headlights, and and and very annoying until a kind member on here suggested the stalk as the likely issue.
I have swapped the wires around so that when i push the stalk it keep the full beams on but when i pull back it should be low. unfortunately no luck on the dipped beams.

1 thing i should add i have 2 aux spot lights. could it be the relay in my drivers side wing?
 
Last edited:
have you located and checked the lighting relay and dim/dip relay .are all the side and tail lights working more info less swapping
 

Attachments

  • Defender MY2002 TD5 EXTERIOR LIGHTS.png
    Defender MY2002 TD5 EXTERIOR LIGHTS.png
    218.4 KB · Views: 119
Strange update.. i must have not done the swap test correct as now when i switched over the cables on the stalk my dip beams are permanently on.
 
Back
Top