Diesel Priming

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
cheezels

cheezels

Member
Posts
94
Location
Tewantin, Australia
Probably been talked to death, but I remember reading that someone suggested putting the old girl in 2nd or 3rd and being towed by a sympathetic friend.

Does that really work? If so, how much bleeding do you need to do before starting the tow? (I've just given mine a birthday. All filters have been replaced (plus oils), so the system is pretty much dry).

Not looking forward to the bleeding.......but if towing will work, then I'll give it a go.

Cheers
 
If you crack the inlet pipe of the the fuel pump off and then pump fuel through using the lift pump or inline hand pump till it flows with out air bubbles, then tighten pipe again.

Crack off all the injector pipes and turn the engine over with the throttle full open. You can tighten them up one at a time when the air has gone. As you tighten them the engine will start to fire then buy the time you get to the last one it will prob be running.
 
Last edited:
hi all u need to do is crack off the bleed screw on to fuel filter pump the handpump get fuel to filter then open bleed screw on rotory pump then try starting if it dont fire crack open one injector pipe . make sure got a good battery!!
 
Yes you can just tow it up to bleed it and it will work just fine, its not too hard a job to do it properly but obviously a lot quicker to just tow it as it becomes a 30 second job.
 
You must log in or register to reply here.

Similar threads

JoeCoutz
TD5 90 2006, loss of drive. No gears work.
Replies
4
Views
418
Spudgun!
S
D
Fix or Ditch?
2
Replies
24
Views
2K
WhiskyLassie
WhiskyLassie
A
2006 L322 4.2 SC - Bluetooth / MOST query
2
Replies
27
Views
2K
kds
K
xDParis64
Right...
Replies
9
Views
1K
pwood999
pwood999
F
My 2006 Freelander TD4 Commerical
Replies
8
Views
593
Andy Warren
Andy Warren
Back
Top