Defender won’t go above 50mph
- Thread starter djmdaniel
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 4,545
Something is wrong, not with the clutch/flywheel I don't think, but somewhere else ...
You need an engine code reader 'Nanocom' for example, to tell you.
You need an engine code reader 'Nanocom' for example, to tell you.
Anaconda
Well-Known Member
- Posts
- 3,554
- Location
- Thames Valley
No it's not right, did it work OK before it went in for the clutch?
If it did then take it back.
Maybe they didn't plug a sensor back in or a pipe of some sort.
If it did then take it back.
Maybe they didn't plug a sensor back in or a pipe of some sort.
Anaconda
Well-Known Member
- Posts
- 3,554
- Location
- Thames Valley
Did you find an answer to your problem?
He's not been back since but it sounds like as above, something wasn't put back after the clutch was replaced
l fitted new glow plugs to my TD5 and after that it ran fine but wouldn't go much above 40mph.
lt seemed like the turbo wasn't working.
l checked and l hadn't reconnected the MAP sensor on the manifold.
Once l plugged that back in all was fine.
l fitted new glow plugs to my TD5 and after that it ran fine but wouldn't go much above 40mph.
lt seemed like the turbo wasn't working.
l checked and l hadn't reconnected the MAP sensor on the manifold.
Once l plugged that back in all was fine.
