defender problems again :( help

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
S

slimworx

New Member
Posts
50
hi all well there samething wrong with the defender yet again
well my brakes stuck on so decided to take the drum off on the end of the transfur box and the nuts holding the prop are siezed and i have tryed allsorts to get them of and now there rounded of

what i want to know is do i need the prop of from the drum side to remove it or can i take the prop of from the back do you know of any good ways of getting them out cheers once again
:D
 
you need to undo the prop at the drum because the bolt go thru the output shaft flange and thru the drum then bolt to the prop.

Get the proper sized imperial spanner which IIRC is 3/8th UNF. or try thin wall 6 sided socket on them there is a proper prop nut tool you can buy that might help.
 
All the ones I've had are 9/16. I've got a favourite old ring spanner with a nice slim ringy bit that I keep specially for propshafts.
 
Probably 9/16ths AF is the same as 3/8th UNF yu know what these old bolt sizes are like. Microcat only covers post 87 defenders (inc 90 &110's) so They may well have changed bolt sizes.
 
You must log in or register to reply here.

Similar threads

S
Knocking in reverse
Replies
3
Views
664
Brown
Brown
suew
Rear Axle Oil Leak
Replies
6
Views
544
suew
suew
Gunter Butfuster
LT230 front output flanges - different sizes
Replies
2
Views
302
Gunter Butfuster
Gunter Butfuster
J
Help please! Electrical issue with 1995 Defender 110 County, 300 tdi
2
Replies
28
Views
792
GRATCH
GRATCH
dconnrt
80's 110 - Braking pulling to the right in wet conditions
Replies
5
Views
529
dconnrt
dconnrt
Back
Top