defender hub
- Thread starter diko93
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
need a bit more of a clue than that ,does seal retainer look like this
http://www.google.co.uk/aclk?sa=L&a...vice=c&icep_msku_flag=n&icep_cbt=n&adtype=pla
or the one below it
http://www.google.co.uk/aclk?sa=L&a...vice=c&icep_msku_flag=n&icep_cbt=n&adtype=pla
or the one below it
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
that would be unless it has a abs sensor in top pin ,chrome ball frc7065 ,kit ma onwards
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
thats number for the chrome ball,to help you choose kit are you after chrome ball as well or just bearing kit .da3178 is full kit
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
da2210 ,though pins dont wear so all you need is 606666 bearings x2 per housing
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
seal you want for chrome ball is ftc3401
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
that would be a very early axle with hexagonal caliper to swivel housing securing bolts, 571890
jamesmartin
Well-Known Member
- Posts
- 91,879
- Location
- louth lincs
gaiters are good as long as they dont get water inside them ,just the bearings is all i do pins arent wearing parts just locaters unlike top bush type ,dont try and remove bottom pin ,bolts often break and its not necessary to ,to change both top and bottom bearing
