bendelaurence
New Member
- Posts
- 234
Defender 3.5 v8 with holley carb???
- Thread starter bendelaurence
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
bendelaurence
New Member
- Posts
- 234
Oh I see thanks I'll have a look
- Posts
- 83,296
- Location
- Embasinga stocæ
bendelaurence
New Member
- Posts
- 234
HAHAHAHA, I was looking on my phone...... its SMALL!!!
- Posts
- 83,296
- Location
- Embasinga stocæ
found the marking on the Holley yet?
bendelaurence
New Member
- Posts
- 234
Been to see the defender today and was most disappointed!! I tapped the chassis with a hammer from one end to the other. Every 10" sounded completely different so i'm guessing there is some fairly major rot underway. The engine and engne bay was covered in slit, so i assume it has spent plenty of time in a river. The engin sounded awsome as you'd expect the v8 lump to, but its not an exageration to say that my old 2.5 N/A had more pull. The futher you put you're foot down, the more noise it made, but it was all revs and no go.
So i think we'll leave that one.
Just found another potential but it's 250 miles away, worth the drive if its a goodun though.
Fingers crossed.
So i think we'll leave that one.
Just found another potential but it's 250 miles away, worth the drive if its a goodun though.
Fingers crossed.
bendelaurence
New Member
- Posts
- 234
Yeah, i finally found one to buy. The marking on the holley is:
8007
2368
Its on a 3.9 v8 out of a discovery.
I've not had any luck finding anything on it yet though.....
bendelaurence
New Member
- Posts
- 234
i think its 390 CFM, is that enough??
