- Posts
- 58,170
- Location
- Preston Lancs.
D2 wheels onto P38
- Thread starter Sir_Ben
- Start date
This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
- Posts
- 19,297
- Location
- Buckinghamshire, UK. ('95 DT)
+1.
In fact I prefer the softer ride of the 16" rims. Better off road too. The 18" rims are slightly more positive on the steering and OK on motorways but not as comfy on our potholed roads. Those are 18" in my avatar.
Datatek
Well-Known Member
- Posts
- 44,886
- Location
- Near Poitiers SW France
I have one on 16's and one on 18's. I prefer the look of the 18's and the ride of the 16's. The 16's are less inclined to shimmy on certain surfaces too.
I would add that fitting Nexen Roadians to the 18's improved both the directional stability and ride, they are wearing very well to and are very quiet.
Last edited:
brianp38dse
Well-Known Member
- Posts
- 20,065
- Location
- heathrow
As far as I know the l322 has the same thread studs as the p38 just smaller heads 22mm against 27 for the p38.
Sir_Ben
Member
- Posts
- 43
- Location
- Pembrokeshire
Thanks for all your helpful suggestions. Seems to me that if the thread size is the same, a set of 27mm D2/P38 nuts should sort it. Failing that, changing the hub studs to standard P38 should allow me to mount the D2 wheels. Can't belief the wheel holes have been enlarged, so it has to be the nuts/studs.
I'm away for a fortnight at the end of the week so won't be doing anything till I get back. I'll report back later.
Cheers All.
I'm away for a fortnight at the end of the week so won't be doing anything till I get back. I'll report back later.
Cheers All.
Last edited:
brianp38dse
Well-Known Member
- Posts
- 20,065
- Location
- heathrow
You probably only need the nuts, I have disco 3 -range rovers sport wheels and used nuts to suit, I just the nut size that differs.
- Posts
- 58,170
- Location
- Preston Lancs.
He will, studs are the same.
